Ever found yourself in a situation where you bought a laptop and found out that it came without its caddy for the hard drive or solid state drive? Or where you inadvertently misplaced the caddy while performing a solid state drive upgrade, and can’t remember where you had last placed it?
Well, if you don’t have a spare hard drive caddy at hand for your laptop, then there is one quick fix that you can try to prevent the hard drive or solid state drive from becoming dislodged from the SATA ports inside the laptop – wedge it in place using rubber!
Find a large piece of solid rubber (something like an eraser for removing pencil marks should do the trick!), and then place it against the edge of the hard drive bay inside your laptop. Then, make a small incision into the rubber using a knife, a scalpel or other suitable sharp blade; the incision should ideally be roughly 1-2mm more than the gap between the edge of the hard drive bay and the edge of the hard drive itself. Then carefully cut through the rest of the rubber, until the piece comes off from the rest of the rubber. Finally, push the cut piece of rubber into the gap, as shown in the above picture.
The idea with this QuickFIXit is that the extra millimetre or two of rubber ensures a tight fit into the gap between the edge of the hard drive bay and the hard drive or solid state drive, which is what keeps the hard drive or solid state drive firmly connected to the SATA ports and thus, prevent them from moving about in the hard drive bay and potentially disconnect, leading to the drives becoming unrecognised in the BIOS and operating systems.